Operating Instructions
1.3 Part Names
1.3.1 Front View
Information
Power LED blinks in the following states.
•
While lens moves to the Home Position after turning on the power.
•
When performing Update Firmware.
•
When you pushed CLEAR SETTING button.
•
The KX-HCM10 hardware is defective. Please refer to Section
4.2 Troubleshooting.
CAUTION
•
Network Camera is intended for indoor use only. Prolonged exposure to direct
sunlight or halogen light may damage the CMOS sensor.
•
If you display the same image on the PC monitor for a long time, damage of
the monitor such as sticking may occur. You should use screen saver.
•
Do not force the movement of the camera while panning or tilting the view. This
can damage the internal drive motors.
•
Do not touch the lens. It may leave a finger print and can cause the image to
be out of focus. This can also damage the protective coating on the lens.
[For assistance : 1-800-272-7033]
Power LED
Fixed Focus Lens
(1m - Infinity)
11