Panasonic KX-HCM10 Operating Instructions Manual page 83

Operating Instructions
Problem
You do not remember
the password to use
the Network Camera
administration web
screen.
The Ethernet network
does not work and the
Ethernet indicator on
the Network Camera is
off.
Pan & Tilt does not
move.
Image is out of focus.
The color of image is
not good.
Image is noisy.
Power LED does not
light up
• Reset the Network Camera by pressing the CLEAR
SETTING button.
The CLEAR SETTING button allows you to initialize all the
parameters of the Network Camera to the factory presets.
Then, reconfigure the Network Camera.
• The Ethernet Cable does not match.
Please check the following contents.
Ethernet Cable
Straight Cable
Category 5
Cross Cable
• It is assumed that communication of Network Camera
and computer is stopped. Please check that the
updating button of a web browser is pushed and the
image has been updated, and operate the Pan & Tilt
function.
• A certain external load may be applied to the Pan & Tilt
operation part. Please check the condition of Network
Camera.
• The lens is dirty or dust is attached.
Please clean with a lens cleaner.
• Please change a white balance setup by camera setting
of Setup Page.
• Please check whether the color of the monitor of a
personal computer is 16 bits or more.
• If a subject is dark, it will become easy to come to image
out of a noise. Please make use environment bright.
• Please check whether standard AC adaptor(PQLV10Y)
is used.
• Please check LED control of an administrator setup.
[For assistance : 1-800-272-7033]
Cause and Remedy
Device
Network Camera
Network Camera
Hub PC
PC
83