Dismantling / Assembling Of The Glass, The Regulator And Burner - Bellfires VENTO CLASSIC SMALL Installation Instructions & Manual For Maintenance

Bellfi res
4 DISMANTLING / ASSEMBLING OF THE GLASS, REGULATOR
AND BURNER
4.1 DISMANTLING
1 Close the gas supply tap.
2 Remove the vertical Left and Right "posts" by lifting them and removing them
sideways.
3 Remove the support "girder" by lifting it and pulling it out.
Note ! : The "girder" and "posts" are made of a fragile
fi reproof material. Place carefully !!!
Wear protective clothing to prevent possible
allergic reactions.
4 Unscrew with several turns the 2 adjustment screws (to fi x the door) left and right
below.
Slide the left adjustment screw completely to the left and the right adjustment
screw completely to the right.
5 The door is now only resting on two supports, Left and Right. Lift the door slightly,
pull it forward, and lower it carefully into the space below. The door can now be
removed from the front.
Use work gloves when removing the door!
6 Remove the log set and the embers.
7 Carefully remove the grill (around the burner). Avoid damaging the decorative walls!
8 Dismantling pilot light: Unscrew the 2 screws next to the pilot light. Remove the wind
guard. Carefully pull the pilot light plate together with the pilot light upwards. You
can now dismantle the fl exible pilot light pipe Ø4 mm, the thermocouple and piezo-
cable from underneath.
9 Dismantling bottom plate including main burner:
Unscrew the 6 bolts, around the burner.
You can now slide the bottom plate backwards, so that you can loosen the
compression fi tting with the fl exible burner pipe Ø8 mm to the main burner at the
front.
52
English
Installation instructions