Bellfires VENTO CLASSIC SMALL Installation Instructions & Manual For Maintenance page 44

Bellfi res
1.7.6 Positioning the ceramic log set
The appliance is delivered with a set of artifi cial wooden logs and embers.
Important: •
•
•
•
•
•
•
Once the front has been removed along with the glass plate, the embers can be
placed on the burner and the ceramic log set can be put in position.
See also Chapter 4, "DISASSEMBLY / ASSEMBLY OF THE GLASS, THE REGULATOR
AND BURNER".
FITTING THE CERAMIC LOG SET.
NATURAL GAS APPLIANCE:
1. Carefully remove the embers (2x 125 gram) from the packaging and place them
evenly on and around the burner.
Note ! Small embers and their residue should not be scattered
on the burner. This can cause a blockage on the burner
orifi ces.
2. Place the logs on the burner: See fi gure 19.
Note ! Small embers and their residue should not be scattered on
: •
the burner. This can cause a blockage on the burner orifi ces.
• Embers must not be placed next to the pilot light burner.
• Important: make sure that all burner openings remain free !!
Burner orifi ces, which are not open, could lead to a dangerous
situation.
44
Carefully place the embers and set of logs on
and around the main burner according to the
directions in this chapter.
Do not place any embers or logs against the
pilot light burner. Make sure that the pilot fl ame
can burn at all times freely over the main burner.
Only in this way is proper ignition of the
main burner ensured.
Ignoring these directions could lead to a dangerous
situation.
Make sure that all burner orifi ces remains free
at all times!
The burner bed (with embers) and the positioning
of the logs must not be changed.
Only use those items supplied! These been rigorously
checked and the quantities adapted to the appliance.
Replacement parts are available from your dealer.
Fitting may only be carried out by a qualifi ed person.
English
Installation instructions