Bellfires VENTO CLASSIC SMALL Installation Instructions & Manual For Maintenance page 41

Bellfi res
1.7.2 Connecting the concentric fl ue
Assemble the concentric fl ue system according to one of the examples in section 1.6.1,
fi gure 4 to 10 inclusive.
Make sure that all connections are completely gas tight.
1.7.3 Building in the appliance
The appliance is supplied from the factory with three decorative elements for the exte-
rior of the fi replace:
• 1x horizontal support girder
• 1x vertical post Right
• 1x vertical post Left
Before building in the appliance, carefully place the "horizontal support girder" (1) and
then the two "posts" (2 and 3) as shown in fi gure 17.
Note! : The "girder" and "posts" are made of a fragile
fi reproof material. Place carefully !!!
Wear protective clothing to prevent possible
allergic reactions.
Figure 17: Placing the girder and the Right and Left posts
Installation instructions
English
41