Bellfires VENTO CLASSIC SMALL Installation Instructions & Manual For Maintenance page 36

Bellfi res
English
Use the four adjustable legs to set the height of the appliance.
See fi gure 12.
Figure 12: Adjusting the built-in height of the appliance
These adjustable legs can be reached after the window and the grill around the burner
have been removed (see Chapter 4).
Position the gas supply pipe such that it can be easily mounted after installation.
Because the control system is outside the appliance, the gas pipe must lead to where
the operating unit (built in), the gas regulating block (and the receiver) assembly are
fi tted.
Move the appliance until it is ± 5 cm from the rear wall and ensure it is level. Place the
nonfl ammable insulation plate (min. 12 mm) between the appliance and rear wall. The
appliance may not be installed against a fl ammable rear wall.
Attach the appliance to the rear wall with 2 wedge bolts. Use the adjustable mounting
brackets at the side of the appliance for this.
36 Installation instructions