Table of Contents
Advertisement
WARNING
■
Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
●
turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. When it is
●
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb. Also, if the bulb is scratched
or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so
●
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
Do not attempt to repair or disassemble the bulb, socket, electrical wiring,
●
or sub components. This may cause serious injury due to electric shock.
Vehicles with discharge headlights:
●
While the low beam headlights are
turned on, and for a short time after they
have been turned off, metal compo-
nents at the rear of the headlight
assembly will be extremely hot. To pre-
vent burns, do not touch these metal
components until you are certain they
have cooled down.
SIENNA_OM_01999-08001_(U)
7-3. Do-it-yourself maintenance
Metal components
525
7
Advertisement
Table of Contents
Troubleshooting
