Table of Contents
Advertisement
250
4-3. Operating the lights and wipers
The sensor sensitivity can be adjusted when "AUTO" is selected.
Increases the sensitivity
6
Decreases the sensitivity
7
Washer/wiper dual operation
8
The wipers will automatically
operate a couple of times after
the washer squirts.
■
The windshield wipers and washer can be operated when
The engine switch is in the "ON" position (vehicles without a smart key sys-
tem) or IGNITION ON mode (vehicles with a smart key system).
■
Raindrop sensor (vehicles with rain-sensing windshield wipers)
The raindrop sensor judges the amount
●
of raindrops.
If the wiper switch is turned to "AUTO" position while the engine switch is in
●
IGNITION ON mode, the wiper will operate once to show that "AUTO" mode
is activated.
If the temperature of the raindrop sensor is 185°F (85°C) or higher, or 14°F
●
(-10°C) or lower, automatic operation may not occur. In this case, operate
the wipers in any mode other than "AUTO".
■
If no windshield washer fluid sprays
Check that the washer nozzles are not blocked if there is washer fluid in the
windshield washer fluid reservoir.
SIENNA_OM_01999-08001_(U)
Advertisement
Table of Contents
Troubleshooting
