Toyota 2015 Sienna Manual page 171

■
Recall procedure
Carry the electronic key that has been registered to the driving
position, and then unlock and open the driver's door using the
smart key system or wireless remote control.
The driving position will move to the recorded position.
If the driving position is in a position that has already been recorded, the
seat and outside rear view mirrors will not move.
■
Cancelation procedure
Carry only the key you want to cancel and then close the driver's
door.
If 2 or more keys are in the vehicle, the driving position cannot be
canceled properly.
Check that the shift lever is in P.
1
Turn the engine switch to IGNITION ON mode.
2
While pressing the "SET" button, press and hold the door lock
3
switch (either lock or unlock) until the signal beeps twice.
If the button could not be canceled, the signal beeps continuously for
approximately 3 seconds.
■
Recalling the driving position using the memory recall function
Different driving positions can be registered for each electronic key. There-
●
fore, the driving position that is recalled may be different depending on the
key being carried.
If a door other than the driver's door is unlocked with the smart key system,
●
the driving position cannot be recalled. In this case, press the driving posi-
tion button which has been set.
■
Customization
The unlock door settings of the memory recall function can be customized.
(Customizable features: P. 624)
WARNING
■
Seat adjustment caution
Take care during seat adjustment so that the seat does not strike the rear
passenger or squeeze your body against the steering wheel.
SIENNA_OM_01999-08001_(U)
3-3. Adjusting the seats
171
3