Toyota 2015 Sienna Manual page 117

■
Switching the door unlock function (vehicles with a smart key system)
It is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the engine switch off.
1
When the indicator on the key surface is not on, press and hold
2
, ,
.
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step
Multi-information
display
For vehicles equipped with an alarm, to prevent unintended triggering of the
alarm, unlock the doors using the wireless remote control and open and close
a door once after the settings have been changed. (If a door is not opened
within 60 seconds after
the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 77)
SIENNA_OM_01999-08001_(U)
3-2. Opening, closing and locking the doors
or for about 5 seconds while pressing and holding
.)
2
Unlocking function
Holding the driver's door
handle unlocks only the
driver's door and driver side
power sliding door.
Holding the front passen-
ger's door handle or pulling
either power sliding door
handle unlocks all doors.
Holding either front door
handle or pulling
power sliding door handle
unlocks all doors.
is pressed, the doors will be locked again and
Beep
Exterior: Beeps three
times
Interior: Pings once
either Exterior: Beeps twice
Interior: Pings once
117
,
3