Table of Contents
Advertisement
The shape of the obstacle may prevent the sensor from detecting it. Pay
●
particular attention to the following obstacles:
• Wires, fences, ropes, etc.
• Cotton, snow and other materials that absorb sound waves
• Sharply-angled objects
• Low obstacles
• Tall obstacles with upper sections projecting outwards in the direction of
your vehicle
The following situations may occur during use.
●
• Depending on the shape of the obstacle and other factors, the detection
distance may shorten, or detection may be impossible.
• Obstacles may not be detected if they are too close to the sensor.
• There will be a short delay between obstacle detection and display. Even
at slow speeds, there is a possibility that the obstacle will come within the
sensor's detection areas before the display is shown and the beep
sounds.
• Thin posts or objects lower than the sensor may not be detected when
approached, even if they have been detected once.
• It might be difficult to hear beeps due to the volume of audio system or air
flow noise of the air conditioning system.
■
If the display flashes and a message is displayed
P. 548
■
Certification (Canada only)
This ISM device complies with Canadian ICES-001.
WARNING
■
When using the Intuitive parking assist-sensor
Observe the following precautions.
Failure to do so may result in the vehicle being unable to be driven safely
and possibly cause an accident.
Do not use the sensor at speeds in excess of 6 mph (10 km/h).
●
The sensors' detection areas and reaction times are limited. When moving
●
forward or reversing, check the areas surrounding the vehicle (especially
the sides of the vehicle) for safety, and drive slowly, using the brake to
control the vehicle's speed.
Do not install accessories within the sensors' detection areas.
●
SIENNA_OM_01999-08001_(U)
4-5. Using the driving support systems
279
4
Advertisement
Table of Contents
Troubleshooting
