Ventilation And Heat Sources; Modem Operating Position - Hughes HN9800 Installation Manual

Ventilation and heat sources

Modem operating position

Chapter 3 • Installing the satellite modem
22
1039707-0001 Revision A
Make sure the installation location meets the following requirements concerning
ventilation and heat sources.
NOTICE
• Do not block any of the modem's ventilation openings.
• Leave 6 inches of space around the top and sides of the modem to ensure
adequate ventilation and prevent overheating.
• Do not place the modem near a heat source such as direct sunlight, a
radiator, heat register or vent, oven, stove, amplifier, or other apparatus
that produces heat.
Install and operate the HN9800 modem only in the upright vertical position resting
on its built-in base as shown in Figure 5. Any other position could result in insufficient
ventilation, overheating, and malfunction.
Figure 5: HN9800 in correct vertical position