Fault Messages In The Display - Miele PW 5065 OS Operating And Installation Instructions

Fault messages in the display

Message in the display
q
Drainage fault
p
Water inlet fault
o
Waterproof system
has reacted
,
Technical fault.
Call Service
,
Fault
Disinfection temp.
not
reached
A To switch off the fault message, press the OK button.
Possible cause
– The water outlet is
blocked or restricted.
– The drain hose has
been fixed too high.
The water inlet is
blocked or restricted.
The water protection
system has reacted.
There is a fault.
During the disinfection
programme the water
temperature was not
reached.
Problem solving guide
Remedy A
LP version: Clean the drain
filter and the drain pump.
AV version: Call the
Service Department.
The maximum drain height
is 1 m.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
– Close the stopcock.
– Call the Service
Department.
Start the programme
again.
If the fault message
appears again, contact the
Service Department.
The machine has not
carried out the disinfection
cycle correctly.
Start the programme
again.
45