Table of Contents
Advertisement
Plumbing
The machine must be connected to the
water supply in strict accordance with
current local and national water
authority regulations.
UK only:
This machine is a WRAS approved
product. To comply with WRAS
requirements, this machine must be
connected to the potable water
supply via the non-return valves
supplied with it.
The machine is designed to operate
with a flow pressure of between 1 and
10 bar (100 kPa and 1,000 kPa). At
higher water pressures it is essential to
fit a reducer valve.
Connection to the water supply should
be carried out by a qualified plumber
and should incorporate a stopcock with
a 3/4" thread. The stopcock should be
fitted by a qualified plumber.
The machine is supplied as standard
with two hoses, for connection to a cold
or a hot and cold water supply.
Installation and connection
Connection to the cold water supply
The cold water inlet hose (blue
stripes) must be connected to the
on-site cold water supply via a 3/4"
threaded union. It is not suitable for
connection to a hot water supply.
,
The connection point is subject
to mains water pressure. Turn on the
stopcock slowly and check for leaks.
Correct the position of the washer
and union if appropriate.
Maintenance and care
Only use a genuine Miele hose should
you ever need a replacement. Miele
hoses are tested to withstand pressure
of at least 70 bar (7,000 kPa).
In order to protect the water inlet
valve, the two dirt filters - one in the
open end of the inlet hose, one at
the inlet point in the machine - must
not be removed.
Extension hose
Longer hoses 2.5 or 4.0 m in length are
available from your Miele dealer or the
Miele Spare Parts Department as
optional extras.
61
Advertisement
Table of Contents
