Tftp Configuration; Tftp Overview; Introduction To Tftp; Operation Of Tftp - HP 5120 series Configuration Manual

TFTP configuration

This chapter includes these sections:

TFTP overview

•
Configuring the TFTP client
•
TFTP client configuration example
•
TFTP overview

Introduction to TFTP

The Trivial File Transfer Protocol (TFTP) provides functions similar to those provided by FTP, but it is less
complex than FTP in interactive access interface and authentication. It is more suitable in environments
where complex interaction is not needed between client and server.
TFTP uses the UDP port 69 for data transmission. For more information about TFTP basic operation, see
RFC 1350.
In TFTP, file transfer is initiated by the client.
In a normal file downloading process, the client sends a read request to the TFTP server, receives
•
data from the server, and then sends the acknowledgement to the server.
In a normal file uploading process, the client sends a write request to the TFTP server, sends data to
•
the server, and receives the acknowledgement from the server.
TFTP transfers files in the following modes:
Binary mode: Transfers files as raw data, like .app, .bin, and .btm files.
•
• ASCII mode: Transfers files as text, like .txt, .bat, and .cfg files.

Operation of TFTP

NOTE:
Only the TFTP client service is available with your device at present.
Figure 29 TFTP configuration diagram
Before using TFTP, the administrator needs to configure IP addresses for the TFTP client and server, and
make sure that there is a reachable route between the TFTP client and server.
When the device serves as the TFTP client, you need to perform the following configuration:
95