Configuring The Ssh Client To Log In To The Ssh Server - HP 5120 series Configuration Manual

Create a HWTACACS scheme, and specify the IP address of the authorization server and other
•
authorization parameters.
Reference the created HWTACACS scheme in the ISP domain.
•
For more information, see the Security Configuration Guide.
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
When the AAA scheme is local, the user privilege level is defined by the authorization-attribute
•
level level command.
• When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the
RADIUS or HWTACACS server.
For more information about AAA, RADIUS, and HWTACACS, see the Security Configuration
•
Guide.

Configuring the SSH client to log in to the SSH server

Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see "Configuration
Figure 14 Log in to another device from the current device
NOTE:
If the SSH client and the SSH server are not in the same subnet, make sure that the two devices can reach
each other.
Configuration procedure
Follow these steps to configure the SSH client to log in to the SSH server:
To do...
Log in to an IPv4 SSH server
Log in to an IPv6 SSH server
requirements."
Use the command...
ssh2 server
ssh2 ipv6 server
50
Remarks
Required
server is the IPv4 address or host
name of the server.
Available in user view
Required
server is the IPv6 address or host
name of the server.
Available in user view