Step-By-Step Patch Installation; Step-By-Step Patch Uninstallation - HP 5120 series Configuration Manual

NOTE:
The patch matches the device type and software version.
•
To uninstall all patches in one operation, use the undo patch install command, which has the same
•
effect as

Step-by-step patch installation

Follow these steps to load a patch file:
To do...
Enter system view
Configure the patch file location
Load the patch file on from the
storage medium to the specified
memory patch area
Activate the specified patches
Confirm the running of the
specified patches
NOTE:
• Set the file transfer mode to binary mode before using FTP or TFTP to upload/download patch files
to/from the Flash of the device. Otherwise, patch file cannot be parsed properly.
This operation is applicable to patches in the ACTIVE state only.
•

Step-by-step patch uninstallation

Follow these steps to stop running patches:
To do...
Enter system view
Step-by-step patch uninstallation.
Use the command...
system-view
patch location patch-location
patch load slot slot-number
patch active patch-number slot
slot-number
patch run patch-number [ slot
slot-number ]
Use the command...
system-view
128
Remarks
—
Optional
flash: by default
Required
In FIPS mode, the patch file must
pass authenticity verification
before it can be loaded.
Required
•
After you activate a patch, the
patch takes effect and is in the
test-run stage. After the device
is reset or rebooted, the patch
becomes invalid.
•
If you find that an ACTIVE patch
is of some problem, reboot the
device to deactivate the patch,
so as to avoid a series of
running faults resulting from
patch error.
Required
After you confirm the running of a
patch, the patch state becomes
RUNNING, and the patch is in the
normal running stage. After the
device is reset or rebooted, the
patch is still valid.
Remarks
—