Configuring Common Settings For Console Login (Optional) - HP 5120 series Configuration Manual

To do...
Set the authentication password
for the local user
Specifies the command level of
the local user
Specify the service type for the
local user
Configure common settings for
AUX user interface view
After you enable command authorization, you need to perform the following configuration to make the
function take effect:
Create a HWTACACS scheme, and specify the IP address of the authorization server and other
•
authorization parameters. For more information about AAA, see the Security Configuration Guide.
Reference the created HWTACACS scheme in the ISP domain. For more information about AAA,
•
see the Security Configuration Guide.
After you enable command accounting, you need to perform the following configuration to make the
function take effect:
Create a HWTACACS scheme, and specify the IP address of the accounting server and other
•
accounting parameters. For more information about AAA, see the Security Configuration Guide.
Reference the created HWTACACS scheme in the ISP domain. For more information about AAA,
•
see the Security Configuration Guide.
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
When the AAA scheme is local, the user privilege level is defined by the authorization-attribute
•
level level command.
When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the
•
RADIUS or HWTACACS server.
• For more information about AAA, RADIUS, and HWTACACS, see the Security Configuration
Guide.
When you log in to the device through the console port after the configuration, you are prompted to enter
a login username and password. A prompt such as <HP> appears after you input the password and
username and press Enter.

Configuring common settings for console login (optional)

Follow these steps to configure common settings for console port login
To do...
Enter system view
Use the command...
•
In non-FIPS mode:
password [ hash ] { cipher |
simple } password
•
In FIPS mode:
password
authorization-attribute level level
service-type terminal
—
Use the command...
system-view
34
Remarks
Required
Optional
By default, the command level is 0.
Required
By default, no service type is
specified.
Optional
See "Configuring common settings
for console login (optional)."
Remarks
—