Configuring Common Console Login Settings (Optional) - HP 3100 v2 Series Configuration Manual

Hide thumbs Also See for 3100 v2 Series:
Table of Contents

Advertisement

The next time you attempt to log in through the console port, you must provide the configured login
username and password.

Configuring common console login settings (optional)

Some common settings configured for an AUX user interface take effect immediately and can
interrupt the console login session. To save you the trouble of repeated re-logins, use a login method
different from console login to log in to the device before you change console login settings.
After the configuration is complete, change the terminal settings on the configuration terminal and
make sure they are the same as the settings on the device.
To configure common settings for an AUX user interface:
Step
1.
Enter system view.
2.
Enable copyright
information display.
3.
Enter AUX user interface
view.
4.
Configure the baud rate.
5.
Configure the parity check
mode.
6.
Configure the number of
stop bits.
7.
Configure the number of
data bits in a character.
8.
Define a shortcut key for
enabling a terminal session.
9.
Define a shortcut key for
terminating tasks.
10. Configure the flow control
mode.
Command
system-view
copyright-info enable
user-interface aux first-number
[ last-number ]
speed speed-value
parity { even | none | odd }
stopbits { 1 | 1.5 | 2 }
databits { 7 | 8 }
activation-key character
escape-key { default |
character }
flow-control { hardware | none |
software }
28
Remarks
N/A
By default, copyright information
display is enabled.
N/A
By default, the transmission rate is
9600 bps.
The default setting is none,
namely, no parity check.
The default is 1.
Stop bits indicate the end of a
character. The more the stop bits,
the slower the transmission.
By default, the number of data bits
in each character is 8.
The setting depends on the
character coding type. For
example, you can set it to 7 if
standard ASCII characters are to
be sent, and set it to 8 if extended
ASCII characters are to be sent.
By default, press Enter to enable a
terminal session.
By default, press Ctrl+C to
terminate a task.
By default, the flow control mode is
none.
The device supports only the none
mode.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3100 v2 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents