Appliance Preparation; Fitting The Battery - Valor BRAVA 348 Installer And Owner Manual

6.2 Appliance preparation.

1. Stand the fire upright.
2. Remove the two transit screws from near the
top of the back panel wings (See figure 6).
3. Remove the two knurled fascia retaining
screws located at the rear of the fascia near the
bottom.
4. Gently pull the base of the fascia forward,
then lift the fascia up and forward to clear the
rear top location. Store in a safe place.
5. Remove the radiant pack by gently lifting and
pulling forward from the bottom.
6. Remove the cardboard strip from the top of
the burner area.
7. Remove any protective film from all the bright
trims.

6.3 Fitting the battery.

Fit the battery to the ignition block located to the
bottom right of the fire (See figure 7). The
locations for the +ve and -ve terminals are
marked on the battery holder.
©
GDC Group Ltd. 2011
INSTALLER GUIDE
Page 17
Figure 6. Transit screws.
Figure 7. Fitting the battery