Settings - Valor BRAVA 348 Installer And Owner Manual

1. Slide the control button to the ignition / low (
electronic ignition system should cause a series of sparks that should light the pilot.
The pilot flame can be seen through a hole immediately in front of the centre radiants
(See the upper section of figure 3). Within four seconds of the pilot igniting, the two
centre radiants should light.
If no sparks are produced to light the pilot, the battery may need replacing. Details of
battery replacement are given further on in this guide.
Until you can obtain a replacement battery the fire can be lit with a taper as described
later in this section of the guide.
2. Keep the button at the ignition / low position (
will prevent the flame-sensing device from shutting off the gas while its probe warms
up as explained previously.
3. Release the button. The button should automatically spring up and the centre
radiants should be fully on.
4. Slide the button up to the medium (M) setting, you should feel a check to the
button movement at this position. The outer radiants should light on their low setting.
5. Slide the control button up again to the high (H) setting, you should feel a check to
the button movement at this position. The outer radiants should now be on their high
setting.

Settings.

The slider control settings are shown in the table below:
Control Positions
IGNITION / LOW (
MEDIUM (M)
HIGH (H)
OFF (O)
Note i) If the flames go out while setting the control, repeat the full lighting
procedure. If the flames repeatedly go out have the fire serviced.
ii) Please note. The radiants will take time to warm up. Although some glow
will be seen after approximately ten minutes, the full visual effect will only be
apparent after a somewhat longer time.
iii) The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to the high (H) setting.
©
GDC Group Ltd. 2011
OWNER GUIDE
Ignition / Centre radiants fully on. Outer radiants off.
L)
Centre radiants fully on. Outer radiants on low.
All radiants fully on.
Pilot and all radiants off.
Page 37
L) position. In this position, the
L) for a further ten seconds. This
Radiants Condition