Safety Information - Martin Atomic 3000 User Manual

Safety information

Warning: This product is for professional use only! It is not for household use.
The Atomic 3000 presents risks of lethal or severe injury due to fire and
heat, electric shock, ultraviolet radiation, and falls. Flashing light is also
known to trigger epileptic seizures in persons who are photosensitive.
Read this manual before powering or installing the fixture, follow the
safety precautions listed below and observe all warnings in this manual
and printed on the fixture. If you have questions about how to operate the
fixture safely, please contact your Martin dealer or call the Martin 24-hour
service hotline at +45 70 200 201.
Protection from electric shock
• Disconnect the fixture from AC power and allow the flash capacitor to
discharge for one minute before changing the lamp or fuse, and when
not in use.
• Do not remove the rear cover: there are no user-serviceable parts
inside.
• Connect the fixture electrically to ground (earth).
• Use only a source of AC power that complies with local building and
electrical codes and has both overload and ground-fault protection.
• Do not expose the fixture to rain or moisture.
• Replace the lamp only as described in this user manual or have it
replaced by a Martin service technician.
Protection from injury, burns and UV radiation
• Never operate the fixture with the front glass open, missing or damaged.
• Do not stare directly into the light. Never look at an exposed lamp while
it is lit.
• Replace the lamp when it becomes defective or worn out.
• A hot discharge lamp is under pressure and can explode without
warning. Allow the fixture to cool for at least 10 minutes and protect
yourself with safety glasses and gloves before opening the fixture,
handling a lamp or servicing the fixture internals.
4 Safety information
1
Atomic 3000 user manual