The Martin logo, the Martin name and all other trademarks in this document pertaining to services or products by Martin Professional A/S or its affiliates and subsidiaries are trademarks owned or licensed by Martin Professional A/S or its affiliates or subsidiaries.
Do not spill fluid over or inside the machine. If fluid is spilled, disconnect AC power and clean with a damp cloth. If fluid is spilled onto electronic parts, take the system out of service and contact Martin for advice. Safety information...
Page 5
• Do not remove the covers or attempt to repair a faulty machine. Refer any service not described in this manual to Martin. • Do not operate the machine if any parts are damaged, defective or missing. • Moisture and electricity do not mix. Do not aim smoke output at electrical connections or devices.
Page 6
P r e v e n t i n g b r e a t h i n g p r o b l e m s • A smoke machine can operate safely only with the smoke fluid it is designed for.
P r o d u c t d e s c r i p t i o n The Jem ZR44 Hi-Mass™ is a reliable and highly efficient fogger capable of precise fog delivery from subtle to massive. Ideal for a variety of settings from...
P r o d u c t d e t a i l s Remove remote control to access Digital remote (accessory) socket. Remote control Main power switch Power inlet connector Dip switch 5 pin DMX 3 pin DMX AVR program (DMX address) input and input and...
S e t t i n g u p Locate the machine in a suitably large area with nothing in front of the smoke output. Fill the fluid tank with MARTIN-approved fluid (see page 16). Connect a suitably rated power supply to the machine. The power requirements are: 8.21A at 230V (EU)
The smoke machine may be located on the floor or may be suspended using the flying bracket. If suspending the machine, a standard truss bracket (available from Martin) should be attached to the machines flying bracket with an M12 bolt and nyloc nut.
4 • the smoke fluid is one of the genuine Martin fluids listed under “Smoke fluid options” on page 16 • the machine is electrically grounded (earthed) •...
Control settings O v e r v i e w The unit is controlled using the remote control. You can control it in these ways: • Manual firing by holding down the FOG button • Automatic fog bursts using a repeating timer M a n u a l f i r i n g Hold down the FOG button.
Digital remote control O v e r v i e w A Digital Remote control, available separately, may be used for control of the JEM ZR44 HI-MASS™ Display XLR socket XLR socket (on rear) Timer button Fog button F u n c t i o n s The remote control provides the following functions: •...
Data + (“Hot”) For best results, use cable designed for high speed digital data transmission. Suitable DMX cable is available from your Martin dealer. D M X f u n c t i o n s The smoke machine operates from a single DMX channel which gives proportional control of fog density from 0-100%.
S e t t i n g t h e D M X a d d r e s s Each unit on a DMX system must be allocated an address so that the DMX controller can send separate commands to the unit. On the smoke machine, the DMX address is set using the bank of switches (“dip switches”) on the back panel next to the DMX connectors.
Fog fluid types The following types of Martin/Jem fog fluid are suitable for use in this machine. Each produces a different effect as described below. Martin supplies high quality fog fluids that are based on ultra-pure deionized water. Use only the following genuine Martin/Jem fog fluids.
Remove the spent fuse and replace with one of exactly the same size and rating. The fuse type is indicated below. Contact Martin Service if the fuse blows repeatedly. 120V = 20AT...
Troubleshooting Problem Probable cause(s) Suggested remedy Machine not at operating Wait 10 to 15 minutes temperature Machine will not produce fog Ensure mains power switch Machine not powered up or when remote control Fog on, enable heaters by heaters disabled button pressed pressing FOG Output level control set to...
Specifications P h ys i c a l Length ......................685mm Width ......................345mm Height ......................225mm Dry weight ....................... 19Kg P e r f o r m a n c e Effect coverage ..................1200m /min Operating time ..................continuous Warm up time ..................
Page 20
Container 9.5L O r d e r i n g i n f o r m a t i o n Jem ZR44 Hi-Mass™ smoke machine 120V ........P/N 92215310 Jem ZR44 Hi-Mass™ smoke machine 230V ........P/N 92215300 A c c e s s o r i e s Digital Multi-function Remote Control ..........
Page 21
Parliament and of the Council of the European Union on WEEE (Waste Electrical and Electronic Equipment), as amended by Directive 2003/108/EC, where applicable. Help preserve the environment! Ensure that this product is recycled at the end of its life. Your supplier can give details of local arrangements for the disposal of Martin products.