Preparation For Use - Martin Atomic 3000 User Manual

Preparation for use

Unpacking
The Atomic 3000 comes with the following items:
• Martin MAX-15 or MAX-7 xenon lamp (installed)
• Mounting bracket
• User manual
The packing material protects the fixture during shipment; always use it to
transport the fixture.
AC power connection
The auto-ranging power supply automatically adjusts to AC power from
100-120 and 200-240 volts nominal at 50/60 Hz. However, a MAX-7 lamp
must be installed at 100-120 V and a MAX-15 lamp for must be installed at
200-240 V.
The current required by the Atomic 3000 varies according to lamp type,
power mode, and usage. To avoid overload, allow one 16 or 20 amp
branch circuit per fixture to operate the MAX-15 model at full power. Two
fixtures may be placed on a 16 amp branch circuit if they are operated in
low power mode or use the MAX-7 lamp.
Use 14 AWG or 2.5 mm
short as possible.
Installing a plug on the power cable
The mains power cable must be fitted with a heavy duty earthed
(grounded) type mains power plug (cord cap). Consult a qualified
electrician if you have any doubts about proper installation.
Follow the plug manufacturer's instructions. Connect the power cable's
yellow and green wire to ground (earth), the brown wire to live, and the
6
2
minimum power feed cables and keep runs as
Preparation for use
2
Atomic 3000 user manual