Service - Martin Atomic 3000 User Manual

Service

Warning: High voltage! Do not remove the rear panel. There are no user-
serviceable parts inside.
Fuse replacement
The Atomic 3000 uses a 20 amp time-delay fuse for protection against
current overload. If the power diode does not light when power is applied,
the fuse may be spent. If the fuse blows repeatedly, there is a fault with the
unit that requires service by a Martin technician.
Never bypass the fuse or replace it with one of another size or rating.
Replacement fuses may be ordered by P/N 05020040.
To replace the fuse:
1. Disconnect the fixture from AC mains power.
2. Unscrew the fuseholder, located on the side plate nearest the power
3. Replace the fuseholder in the side plate.
Firmware updates
If you suspect that the firmware installed on your Atomic 3000 has
become corrupted, please contact your Martin dealer for assistance.
22
cable. Remove the spent fuse from the holder and replace it with an
identical 20 amp 6.3 x 32 mm time-delay fuse.
Service
7
Atomic 3000 user manual