Martin Atomic 3000 User Manual page 19

Atomic Detonator
Chase/Sync toggle
Intensity control
Blinder effect
The optional Detonator remote control provides the following:
• Slider controls for flash rate and intensity
• Momentary push button control of the blinder effect
• Momentary push button for single flash and flash synchronization
• Run/stop toggle switch
• Chase/sync toggle switch
Data connection
Important: Do not terminate the data link when using the Detonator!
The Detonator connects to the Atomic 3000 with a 3-pin XLR data cable.
Additional Atomic 3000s may be connected in series, output to input, for
remote control of up to 20 fixtures. Note, however, that the data link must
not be terminated as described DMX controllers.
If a signal splitter is used to branch the data link, it must be placed after
the master fixture (see below), as the splitter does not transmit power to
the remote control.
Mode setting
Important: Connect no more than 1 master to the remote control!
Atomic 3000 user manual
Run Stop
Chase Sync
Remote controls
Run/stop toggle
Flash rate control
Single flash and
synchronization
19