Cleaning - eka ekf 711 p Use And Instruction Manual

Electric Oven rev. 0 _____________________________________________________________EKF 711 P – EKF 664 P
Cleaning the door - The glass panel of the door facing inwards toward cooking compartment Cleaning the door
Cleaning the door Cleaning the door
can be cleaned with the same type of degreasing product used to clean the compartment.
Otherwise, you can use normal glass cleaning product (non toxic). A common glass detergent
can be used also to clean the glass panel of the door facing outward. In all cases, you may just
use tepid soapy water. After rinsing, thoroughly dry the glass surface with a soft cloth. If
opaque sections form between the two glass panels of the door, they can be eliminated after
dismantling the internal glass panel.
Cleaning the fans Cleanin g the fans - The fans must be periodically cleaned with specific anti-lime scale products.
Cleanin Cleanin g the fans g the fans
All the parts must be carefully cleaned, removing all lime scale deposits. To have access to the
fans remove the fan casing after removing the screws that fix it to the cooking chamber. When
cleaning is complete, replace the casing and screws.
Cleaning the door seal - For hygiene and good operations, it is good practice to clean the door Cleaning the door seal Cleaning the door seal Cleaning the door seal
seal at the end of each day's work. It should be carefully washed with warm soapy water, rinsed
and dried with a soft cloth. Any incrustations or food deposits must be carefully removed,
without using sharp metal tools which could irreparably damage the seal.
10. Maintenance 10. Maintenance
10. 10. Maintenance Maintenance
General information - A periodic control (at least once a year) of the appliance aids to guarantee General information General information General information
long life and correct operations. Any sort of maintenance work on the appliance must be done
exclusively by technically qualified operators who have been trained in the maintenance work
on this appliance. Before beginning any sort of maintenance work on the appliance, turn the
power supply off (at the magnetothermal safety switch upstream from the appliance) and let it
cool down. Access is gained to the inside components that could require maintenance work by
removing the left side of the appliance.
Changing the lighting lamp in the cooking chamber - The lamp is housed between the two Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber Changing the lighting lamp in the cooking chamber
door glasses; to replace it remove the internal glass as described in the paragraph: "Cleaning
the door". After removing the internal glass, replace the lamp with another with the same
specifications: 12V 35W 300°C (this is a halogen lamp and should not be touched with your
bare hands).
Changing the door seal - The door seal has a rigid profile with 3 fixing tabs. The profile must be Changing the door seal
Changing the door seal Changing the door seal
fitted into the guide on the face of the cooking chamber. The rectangular seal fits perfectly into
the frame of the guide and, therefore, the seal profile fits perfectly onto the face of the cooking
chamber. To change the seal, remove the old one from the guide by pulling hard at the four
corners. Clean any dirt from the guide and introduce the new seal (to make this operation
easier, we advise dampening the seal profile with soapy water).
Resetting the thermal breaker safety device - This device is reached by removing the left side of Resetting the thermal breaker safety device
Resetting the thermal breaker safety device Resetting the thermal breaker safety device
the appliance and can be reset by pressing the red key right down (which is marked by a special
adhesive label), which is inside the electric components compartment.
___________________________________________________________________________________________ page 9