Maintenance - eka ekf 711 p Use And Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

TECNOEKA Srl ______________________________________________________________ use and instruction manual

Possible faults

Type of fault

Control panel

completely off (the oven

does not work)

Cooking cycle set: the

oven does not work

Door closed: steam

comes out of the seal

The oven does not cook

evenly

Lighting lamp in the

cooking chamber does

not work

The thermo safety

device turns on in

continuous

11. Technical service

Before leaving the factory, the appliance was completely regulated and tested by expert

specialised personnel to guarantee the best operating results.

All repairs and settings must be performed with utmost care and attention, respecting national

safety regulations in force. Always contact your retailer or our nearest Service Centre, giving

details of the problem, the appliance model and the serial number (on the rating plate on the

rear panel). For any maintenance the user can contact Tecnoeka by calling the telephone

numbers on the cover or going to

12.

12. Informations to the consumers

12.

Informations to the consumers

Further to Directive 2002/96/EC, the symbol of the crossed rubbish skip on

the appliance means that at the end of its life, the product must be disposed

of separately from the other rubbish. The user must hand the appliance to a

specialised waste collection centre for electric and electronic equipment.

The separate collection of the rubbish and subsequent treatment, recovery and disposal help to

produce other equipment using recycled materials, reducing the negative effects on the

environment and public health, which would be caused by incorrect management of the

rubbish. Should the user dispose of the product abusively, administrative sanctions would be

applied.

page 10 __________________________________________________________________________________________

Cause

- Incorrect electric connections to the

mains

- No mains voltage

- Thermal break safety device tripped

- Door open or ajar

- Damaged magnetic sensor

- Seal not fitted correctly

- Damaged seal

- Handle prong loosened

- One of the motors is blocked or turns

slowly

- The motors do not go into reverse

- Heating element not powered or is

damaged

- Damaged lamp

- Damaged lamp feeder

- Device damaged

- Regulating thermo state damaged

www.tecnoeka.com.

www.tecnoeka.com

Corrective action

Corrective act

ion

Corrective act

ion

- Check the mains connection

- Restore mains voltage

- Reset the thermal break safety

device

- Close the door