Table of Contents
Advertisement
Lubrication
Cutting device
Safety devices / spare parts
000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255
Observe the specified oil change intervals and oil
types for the transmissions. Use only high quality
brand lubrication grease, e.g. multi-purpose grease
Shell Retinax A EP 2 to lubricate the machine.
Before the lubrication process clean all grease nipples
from dirt. Lubricate in regular intervals according to the
lubrication plan.
Environment!
Store lubricants in suitable vessels and ensure
appropriate waste disposal.
To lubricate the wheel hub bearings only use brand
name grease Lithium EP ("lithium base soap") with a
drop point of between 180 °C and 190 °C (356 °F and
374 °F). Fill the wheel hub bearings with fresh grease
every 1000 operating hours. Lubricate all other
lubrication points as shown in the lubrication schedule.
Attention!
Too much lubricant can damage the
bearings.
Danger!
There is always a risk of injury when working
on the cutting facility! Wear gloves.
Blunt knives cause an unnecessarily high fuel
consumption.
Danger!
After the completion of maintenance wok
re-establish the function of all safety devices.
If safety devices are subject to
wear, these must be checked at regular
intervals and replaced in due time.
Spare parts must at least meet the technical
requirements specified by the equipment
manufacturer. This is guaranteed e.g. when
using original spare parts.
Maintenance
14.1.3
Advertisement
Table of Contents
