Claas Communicator (Rollant 254/255 Optional); Removing The Hydraulic Hoses And Cables; Propeller - Claas ROLLANT 240 Operating Instructions Manual

S
000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255
C
D
7
A
8
9

Claas Communicator (ROLLANT 254/255 optional)

If the round baler is hitched, insert the Claas
Communicator (C) into the holder provided (D) behind
the right screen.
Note!
In order to prevent water from entering, the
control box or Claas Communicator must be
hung so that the cable sockets are on the
bottom.
When cleaning the baler with steam jets or high
pressure jets, always remove the control box or
Claas Communicator beforehand.
(Fig. 7)

Removing the hydraulic hoses and cables

Disconnect the hydraulic oil hoses and electrical
cables from the tractor. Close the snap-fit connections
with dust caps.
Attention!
Always disconnect the pressure line (thin
hose) first and then the return flow line (thick
hose) from the tractor. Never attach the
pressure line alone to the tractor.
Hang the snap-fit connections for the hydraulic hoses
and the cable plugs in the slot (A) on the platform.
(Fig. 8)

Propeller

Pull the propeller shaft off the tractor.
For counterweight hitches, place the propeller shaft
onto the supports (S) provided for the purpose.
(Fig. 9)
After using the baler
13.1.3