Table of Contents
Advertisement
G N
1
2
3
4
28268
000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255
Manual net wrapping
When the baling chamber is completely full, the baler
reaches the set hydraulic baling pressure. The tailgate
is pushed open about 5 cm (1.97 in). The red control
light in the rotary switch (1) slowly begins to blink.
Now stop the tractor. Release the net wrapping with
the pushbutton switch (4). The red control light in the
A
pushbutton switch (3) goes on and the buzzer sounds.
The net is fed in and taken up by the rotating bale after
E
the delay time.
Wrapping ends
The red control light in the rotary switch (1) blinks
slowly and the buzzer stops. The control light in the
pushbutton switch (3) goes out.
For twine wrapping, the end of the wrapping process is
also recognizable when the twine tubes stop.
For net wrapping, the end of the wrapping process is
also recognizable when the roll of netting stops or
when you hear the cutting of the net by the knife.
(Fig. 3)
3
Operation
9.1.3
Advertisement
Table of Contents
