Round Baler With Net Wrapping; Round Baler With Twine And Net Wrapping; Round Baler With Twine Wrapping - Claas ROLLANT 240 Operating Instructions Manual

7
2
000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255

Round baler with net wrapping

Press push button (2) on the control box to activate the
net wrapping system. The status display (light) (7)
confirms the selection "net wrapping".

Round baler with twine and net wrapping

Balers with twine and net wrapping are factory-set to
twine wrapping by default.
To change from twine to net wrapping and vice-versa:
– Adjust drive
– press pushbutton (1 or 2) on the control box to
8
The status display (light) (7 or 8) shows the active
1
wrapping mode.
During the compression process, the ROLLANT 254/
255 with High Convenience Operation handles these
settings from the control panel or Claas
Communicator.
5

Round baler with twine wrapping

Press pushbutton (1) on the control box to activate the
12
twine wrapping system. The status display (light) (8)
confirms the selection "twine wrapping".
(Fig. 12)
(see chapter "Adjusting the baler") and
activate the net or twine wrapping.
Note!
When initiating the wrapping process make sure
that both twine ends are drawn in. If only one
twine end is drawn in run the wrapping process
to the end and restart it by pressing push button
(5).
Operation
9.2.9