Claas ROLLANT 240 Operating Instructions Manual page 124

Setting up the baler
E
E
net wrapping
C
C
E
E
twine- and net wrapping
8.3.2
C
C
A
B
Note!
If there are problems starting the baling for net
binding or net and twine binding, attach end
stops (A) 845037.0 or for twine binding, attach
end stops (B) 838789.0.
Open the side flaps and dismantle the right and left
protective panels.
Release the tension on the tension springs for the
oscillating section.
Use the hoist to lift the oscillating section and lift up to
the end stop.
For machines with net binding or with twine and net
binding, position end stop (A) and fasten screws (C)
and contact washers (E).
(Fig. 3)
3
For machines with twine binding, position the end stop
(B) and fasten with screws (C) and contact washers
(E).
(Fig. 4)
4
BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5