Table of Contents
Advertisement
Operation
G N
1
2
3
4
28268
9.1.2
Automatic twine and net wrapping
When the baling chamber is completely full, the baler
reaches the set hydraulic baling pressure. The tailgate
is pushed open about 5 cm (1.97 in). The red control
light in the rotary switch (1) slowly begins to blink.
Wrapping is started automatically.
Twine wrapping:
A
With twine wrapping, first the strands are taken up
E
(about the circumference of one bale).
As soon as the twines strands are taken up by the
bale, the red control light goes on in the pushbutton
switch (3) and the buzzer sounds.
Now stop the tractor.
Automatic net wrapping:
2
The red control light goes on in the pushbutton switch
(3) and the buzzer sounds.
Stop the tractor.
The net is fed after the delay time and is taken up by
the rotating bale.
(Fig. 2)
Note!
When starting twine wrapping, make sure that
both twine ends are pulled in by the bale. If only
one of the twine ends has been pulled in, allow
the wrapping process to continue. When it has
finished, repeat the process manually by
pressing the pushbutton switch (4).
BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Advertisement
Table of Contents
