Setting The Delay Period To Automatic Net Binding; Cutting Device (Roto Cut); Swashing The Knives In - Claas ROLLANT 240 Operating Instructions Manual

S
10
4
6
000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255

Setting the delay period to automatic net binding

The delay period can be set from a minimum of 1
second to a maximum of 10 seconds.
Have a watch with a second hand available when
adjusting the delay time. Read the following steps very
carefully and then carry them out in quick succession.
1. Press and hold down the pressure switches (5)
and (6), and only then switch on the operating
box; this switches to learn mode.
The operating box is in learn mode when the stop
symbol (S) lights up and there is an audible
warning signal.
2. Now use the watch to measure the time. Let go of
the pressure switch when you reach the desired
delay time.
9
3. Switch off the operating box and then switch it on
again.
3
The compressor is now ready for operation and the
time delay setting activated.
5
14

Cutting device (ROTO CUT)

Swashing the knives in

1. Actuate push button (3). The light (9) confirms the
selection.
2. Raise the pick-up completely with the tractor
hydraulics. The knives are thereby swashed in via
the hydraulic cylinders. The pick-up can then be
lowered again.
Note!
If the delay time is set to 10 seconds, net
wrapping is automatically set to manual
wrapping. Net wrapping is activated by pressing
key (5).
Operation
9.2.11