Configuring The Lmi Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 Frame Relay Testing

Configuring the LMI Settings

Configuring the LMI Settings

16
Setting
C/R Bit Tx
DLCI Rx
Lng Frm Rx
Thresh
4 Do one of the following:
– To configure other test settings, press a different soft
key.
– To return to the test result display area, press the
Home navigation key.
The frame header settings are configured.
Local Management Interface (LMI) is a signaling mechanism
often used on frame relay networks to communicate informa-
tion about the status of a network connection. With the Frame
HST-3000 Frame Relay Testing User's Guide
Parameters
Enter one of the following values for the
command/response field bit:
– 1: Indicates the field is checked.
– 0: Indicates the field is blank.
Enter a value, from 0 to 1023, for the
received data link connection identifier
(DLCI). The HST will display test results
for the traffic on this DLCI in the DLCI
result category; results for the entire link
appear in the Link result category.
Enter a value, from 5 to 9999 bytes, to
indicate the long frame receive threshold.
The HST will maintain a count of received
frames that exceed the specified thresh-
old.