Transmitting Traffic Over A Datacom Interface - JDS Uniphase HST-3000 User Manual

Transmitting
The HST can also transmit frame relay traffic over a Datacom
traffic over a interface.
Datacom
To transmit frame relay traffic over a Datacom interface
interface
1 Access the test configuration menus for Datacom testing.
2 Review the Summary Settings.
3 Press the DATACOM soft key.
4 Select a setting, and then specify the parameters. For
5 Specify the frame load settings. See
6 Specify the frame header settings. See
7 Specify the local management interface settings. See
8 Specify how link trace results should be displayed. See
HST-3000 Frame Relay Testing User's Guide
See "Accessing the test configuration menus" on page
The Summary Settings screen appears. This screen
provides the most important settings for the test.
If the settings are appropriate for your test, press the
Home key and proceed to
To change the settings, do one of the following:
– Navigate to the desired item by selecting the item
number using the keypad
– Use the arrow keys to highlight the item and then
press OK.
If you want to configure additional settings, proceed to
step 3.
The Datacom Settings menu appears.
details on the Datacom settings, see the HST-3000 Data
Communications Testing User's Guide.
frame load settings" on page
frame header settings" on page
"Configuring the LMI Settings" on page
"Configuring the trace settings" on page
Chapter 2 Frame Relay Testing
Generating traffic loads
step 11.
"Configuring the
11.
"Configuring the
14.
16.
19.
8.
33