About Frame Relay Testing; Hst-3000 Frame Relay Testing User's Guide; Accessing The Test Configuration Menus - JDS Uniphase HST-3000 User Manual

Chapter 2 Frame Relay Testing

About frame relay testing

About frame relay testing

Accessing the test configuration menus

8
After the physical interface has been verified, you can use the
HST-3000 Frame Relay option to monitor frame relay traffic,
and to transmit and receive frame relay frames to commission
and maintain frame relay services.
When you purchase the Frame Relay testing feature, results
such as LMI message stats, error results, DCLI status, and
link trace results are available. Additionally, all the results
related to the physical interface are available. For details on
the interface results, see the following guides:
– HST-3000 T1 Testing User's Guide
– HST-3000 E1 Testing User's Guide
– HST-3000 Data Communications Testing User's Guide
– HST-3000 DDS Local Loop Testing User's Guide
The following sections describe how to configure an
HST-3000 with the Frame Relay option to perform test opera-
tions.
NOTE:
Before you can perform a test operation, you must connect
a SIM to the base unit and power on the HST-3000. For
information on connecting a SIM and powering the unit, see
the HST-3000 Base Unit User's Guide.
For information about purchasing the Frame Relay option or
other HST products, contact an JDSU sales representative.
The following procedure describes how to view the menus you
will use to configure the test settings.

HST-3000 Frame Relay Testing User's Guide