Transmitting Traffic Over The Dds Four-Wire Local Loop In; Terface - JDS Uniphase HST-3000 User Manual

Chapter 2 Frame Relay Testing
Generating traffic loads
Transmitting
traffic over the
DDS four-wire
local loop
interface
34
9 For details on configuring flow control, the User LEDs, or
polarity settings, refer to the HST-3000 Data Communica-
tions Testing User's Guide.
10 After you finish configuring the test settings, press the
Home navigation key.
11 Connect the HST to the circuit. For more information, see
the HST-3000 Data Communications Testing User's
Guide.
12 To begin transmitting traffic, press the Start soft key.
The HST transmits frame relay traffic over the Datacom inter-
face.
Using an HST with a DDS four-wire local loop (DDS-4WLL)
SIM and the Frame Relay option, you can generate and
receive frame relay traffic.
To transmit traffic over the DDS-4WLL interface
1 Connect a SIM with DDS four-wire local loop testing capa-
bility to the base unit, and then power on the HST-3000.
For information about connecting a SIM and powering on
the unit, see the HST-3000 Base Unit User's Guide.
2 Access the test configuration menus for DDS four-wire
local loop testing. See
menus" on page
The Summary Settings screen appears. This screen
provides the most important settings for the test.
3 Review the Summary Settings.
If the settings are appropriate for your test, press the
Home key and proceed to
HST-3000 Frame Relay Testing User's Guide
"Accessing the test configuration
8.
step 11.