Mounting The Camera - JVC VN-X35U Instructions Manual

VN-V25U_26U_EN.book Page 21 Wednesday, September 3, 2008 8:03 PM

Mounting the Camera

Use the screw hole on the camera mounting
bracket to mount this camera to a fixer or rotating
platform.
Camera
Mounting
Camera Mounting
Screw Hole
Bracket Fastening Screw
(2 pcs: M2.6 x 6 mm)
Anti-rotation Hole
2 mm and below
Mounting the camera mounting
bracket on the top of the camera
Camera
Mounting
Bracket
Note:
● When mounting the camera, use screws with
a length between 5 mm to 7 mm from the
mounting surface. Screws beyond the
specified length may damage the interior,
Camera
while those shorter than specified may cause
Mounting
the camera to fall off, and therefore these
Bracket
must not be used.
Fall
Prevention
Wire
M3x6 mm
(15/64 inch)
6 mm
Note:
● The camera mounting bracket is mounted on
2 mm and below
the bottom surface of the camera by default.
To mount it to the top surface, do so by
removing the two fastening screws from the
camera mounting bracket. Make sure to
fasten the screws firmly.
1/4-20UNC
5 mm and
above
7 mm and
below
21