Mounting The Camera - JVC VN-X35U Instructions Manual

Mounting the Camera

● Use the screw hole on the camera mounting
bracket to mount this camera to a fixer or
rotating platform.
Mount the fall prevention wire using the black
screw at the rear of the camera unit.
Camera
Mounting
Camera Mounting
Screw Hole
Bracket Fastening Screw
1/4-20UNC
(2 pcs: M2.6 x 6 mm)
Anti-rotation Hole
Camera
Mounting
Bracket
Fall
Prevention
Wire
M3x6 mm
(15/64 inch)
6 mm
2 mm and below
Mounting the camera mounting
bracket on the top of the camera
The camera mounting bracket is mounted on the
bottom surface of the camera by default. To
mount it to the top surface, do so by removing
the two fastening screws from the camera
mounting bracket. Make sure to fasten the
screws firmly.
Camera
Mounting
Bracket
Note:
● When mounting the camera, use screws with
a length between 5 mm to 7 mm from the
mounting surface. Screws beyond the
specified length may damage the interior,
while those shorter than specified may cause
the camera to fall off, and therefore these
must not be used.
5 mm and
above
7 mm and
below
1/4-20UNC
21