Setup Procedures - JVC VN-X35U Instructions Manual

VN-V25U_26U_EN.book Page 15 Wednesday, September 3, 2008 8:03 PM

Setup Procedures

Step 1 Connection/Installation (A Page 16)
Connect the lens mount, power supply cord,
LAN cable and alarm cable.
Next, mount the camera to the ceiling. Make
sure to attach the fall prevention wire firmly to
the camera. After the camera is mounted,
connect the video monitor to the [MONITOR
OUT] terminal at the rear of the unit, followed
by adjusting the camera angle.
You can select the video signals of the
[MONITOR OUT] terminal using the
[MONITOR OUT] switch. (ANTSCBor APALB)
ABack Focus AdjustmentB (A Page 23)
A[MONITOR OUT] Monitor Output Selection
SwitchB (A Page 11)
T After adjusting the camera angle using the
[MONITOR OUT] terminal, set the
[MONITOR OUT] switch to AOFFB. Images
are not distributed to the network when
ANTSCB or APALB is selected. After changing
the [MONITOR OUT] switch setting, press
the Reset button to reboot the camera.
G
Step 2 Network settings (A Page 27)
Configure the network settings of the
computer and this camera.
T In a system where multiple units of VN-X35U
are used, turn on the power of only one unit
to configure the IP address settings using the
Internet Explorer. Upon doing so, turn on the
power of the second unit and configure
accordingly. Configure the settings for the
other cameras using the same procedure.
G
Step 3 Configuring settings using the
Internet Explorer (A Page 33)
Configure the picture quality and alarm
settings using the Internet Explorer.
G
Step 4 Operating the built-in viewer
(A Page 86)
The integrated enables you to monitor JPEG
or MPEG4 images, send/receive audio data,
perform PTZ operations, and register preset
positions.
15