Name And Function Of Parts; Front / Bottom / Side - JVC VN-X35U Instructions Manual

VN-V25U_26U_EN.book Page 10 Wednesday, September 3, 2008 8:03 PM
Getting Started

Name and Function of Parts

Front / Bottom / Side

A
B
C
A
Back Focus Adjustment Ring
This ring is used for adjusting the back focus.
To operate, loosen the I back focus fastening
screw by turning it in the anti-clockwise direction,
and turn the screw in the clockwise direction to
fasten after operation is complete.
This product is pre-adjusted to a position that is
best suited for CS mount.
(A Page 23)
B
Lens Mount
This is a mount for mounting the lens.
The mount is compatible with CS mount lens
and C mount lens.
(A Page 16)
C
Camera Mounting Bracket Fastening
Screw (2 pcs: M2.6 x 6 mm)
Use screws with a length of 6 mm. Screws
beyond the specified length must not be used as
doing so may damage the interior.
D
Anti-rotation Hole
Use this anti-rotation hole to mount the camera
firmly.
E
Camera Mounting Screw Holes(1/4-20UNC)
Use this hole when mounting this product to a
fixer or rotating platform.
Use screws with a length between 5 mm to
7 mm. Screws beyond the specified length may
damage the interior, while those shorter than
specified may cause the camera to fall off, and
therefore these must not be used.(A Page 21)
10
H
G
F
E
D
F
[MAC address] Indicator
The MAC address is a unique physical address
of the product. This address cannot be altered.
G
Camera Mounting Bracket
This bracket is pre-mounted to the bottom
surface of the camera. It can also be mounted to
the top surface according to the usage. Mount it
to the screw holes at the top surface using the C
camera mounting bracket fastening screws.
(A Page 21)
H
[BF LOCK] Back Focus Fastening Screw
This is the fastening screw for the back focus
adjustment unit. (A Page 23)
I
Inner Tripod Base Screw Hole (1/4-20UNC)
Use this hole when mounting this product to a
miniature housing.
You can mount to the housing through this hole
directly without using the G camera mounting
bracket.
(A Page 22)
I