Adjusting Zoom and Focus
Mounting the Camera
Loosen the zoom lever (D) / locking screw by turning it counter-clockwise.
Rotate the zoom ring to achieve the desired picture.
Loosen the focus lever (E) / locking screw by turning it counter-clockwise.
Rotate the focus ring to adjust the focus.
If re-adjustment is necessary, repeat the steps above.
Retighten the zoom lever (D) / locking screw and the focus lever (E) / locking screw.
Caution
Retighten the locking screws to prevent loss of adjustment.
Place the guide pattern sticker (supplied) on the mounting surface and
mark three holes according to the guide pattern sticker. Then fasten the
sticker to the mounting surface with screws.
Connect the Safety Wire (Fall Prevention Wire, not supplied) to the camera
and the ceiling.
Secure the camera bottom case (1) to the wall/ceiling with tapping screws,
supplied.
Adjust the view angle (zoom, focus, and Horizontal Rotation).
Safety Wire
(Fall Prevention Wire, not supplied)
7