Power Connection; Connecting To The Ac 24 V Power Supply - JVC VN-X35U Instructions Manual

VN-V25U_26U_EN.book Page 17 Wednesday, September 3, 2008 8:03 PM

Power Connection

Electricity can be supplied to this product either
by connecting to the AC 24 V power supply or
using the PoE (A Page 18).
When power is supplied to this product, the
[STATUS] indicator at the side lights up. The
indicator lights up in orange color during
startup, and switches to green color after
startup is complete.
Memo:
You can select not to light up the [STATUS]
indicator when the unit is running. (A Page 75)
Note:
● Make sure to select only one mode of electrical
supply. Connecting the power cord and the
LAN cable for the PoE at the same time may
result in failure or malfunction of the camera.
● Be sure to use an AC 24 V supply that is
isolated from the primary power supply
circuit. Using a variable voltage power supply
will cause the camera and system to
malfunction or breakdown.
Connecting to the AC 24 V power
supply
Connect this product to the AC 24 V power
supply when the PoE is not used.
Note:
● Make sure to select only one mode of electrical
supply. Connecting the power cord and the
LAN cable for the PoE at the same time may
result in failure or malfunction of the camera.
● The unit is to be powered by an AC 24 V
power supply.
The AC 24 V power supply should conform to
the following: Class 2 only (For USA),
Isolated power supply only (For Europe and
others).
1 2
G
AC24V
MONITOR
OUT
10BASE-T/
SEE INSTRUCTION MANUAL 100BASE-TX
CAUTION
PoE AC 24V
: NEVER USE AND
DO NOT CONNECT TO THE TELEPHONE NETWORK
To Power
Supply
2 1 2 1
ALARM
AUDIO
AT THE SAME TIME
PUSH
MONITOR OUT PAL
STATUS
[STATUS] Indicator
Power cord
● To prevent misconnection and detachment of
cords, use a lug plate to connect the cord to
the terminal.
● When a two-core VVF (vinyl insulated vinyl
sheath cable) is used, the connection
distance is as follows. (Reference value)
R1.0 mm
Conductor Diameter
(AWG No.) (18) and
above
Maximum Extension 140 m
Warning
The rated power of this product is AC 24 V,
50 Hz/60 Hz. Make sure to use it with the
correct voltage.
Use an AC 24 V supply that is isolated from
the primary power supply.
Supplying a power beyond the rated value
may result in failures, smoke or fire. When the
camera breaks down, turn off the power and
contact our service center immediately.
When a power beyond the rated value is
supplied, the internal components may be
damaged even if no abnormality is found on
the appearance and operation of the camera.
Please contact our service center immediately
for servicing (charged separately).
Memo:
● After DHCP timeout, all IP addresses of
VN-X35Us are set to 192.168.0.2 by default.
When the power of multiple cameras within the
same LAN environment are turned on at the
same time, the IP address of the cameras
overlap, thus preventing proper access. As such,
make sure to turn on the power of the cameras
one by one.
OFF NTSC RESET
IRIS
R1.6 mm R2.0 mm
(14) and (12) and
above above
360 m 570 m
17