Monitor Signal Output Terminal Connection; Audio Signal Input/Output Terminal Connection - JVC VN-X35U Instructions Manual

VN-V25U_26U_EN.book Page 19 Wednesday, September 3, 2008 8:03 PM
Monitor Signal Output Terminal
Connection
Make use of this terminal for camera angle
adjustment during installation or focus
adjustment in the Focus Assist mode. Connect it
to devices such as a video monitor using a video
cable (RCA).
Memo:
●
It is convenient to adjust focus using
focus assist mode.
(A Page 24)
1 2
AC24V
MONITOR
OUT
10BASE-T/
SEE INSTRUCTION MANUAL 100BASE-TX
CAUTION
PoE AC 24V
: NEVER USE AND
DO NOT CONNECT TO THE TELEPHONE NETWORK
Note:
● A longer cable extension distance causes
signals to be attenuated, image resolution to
deteriorate and noise to increase.
Memo:
● Select the signal system for the monitor output
using the [MONITOR OUT] switch at the side of
this product. (ANTSCB or APALB)
After adjusting the camera angle, set the switch
to AOFFB. After changing the switch settings,
press the Reset button to reboot the camera.
G 2 1 2 1
ALARM
AUDIO
AT THE SAME TIME
PUSH
Audio Signal Input/Output
Terminal Connection
Connect the mini jack R3.5 stereo cable.
L ch : Speakers with built-in amplifier, etc.
R ch : Plug-in power type capacitor microphone
1 2 G
2 1 2 1
1 2 G
AC24V
MONITOR
OUT
AUDIO
10BASE-T/
SEE INSTRUCTION MANUAL 100BASE-TX
CAUTION
PoE AC 24V
: NEVER USE AND AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
PUSH
Line Out
L ch
R ch
Note:
● Make sure that the external microphone is
connected to the R ch and not other
channels. Some transmission system
settings (A Page 49) may cause loud noises
to be distributed when the microphone jack is
plugged directly into the unit's [AUDIO IN/
OUT] terminal.
Speakers with
Built-in Amplifier
Condenser
microphone
compatible with
plug in power.
19