Side - JVC VN-X35U Instructions Manual

Megapixel ip camera
Hide thumbs Also See for VN-X35U:
Table of Contents

Advertisement

VN-V25U_26U_EN.book Page 11 Wednesday, September 3, 2008 8:03 PM

Side

J
[MONITOR OUT] Monitor Output Selection
Switch
Use this switch to select the availability of output
from the N [MONITOR OUT] terminal as well as
the signal system.(A
Page 12)
NTSC : Outputs NTSC signals.
OFF
: No output. Select this value when
distributing images to the network.
PAL
: Outputs PAL signals.
[Default setting: OFF]
Note:
● Images are not distributed to the network
when ANTSCB or APALB is selected.
● When the switch is changed, press the K
[RESET]button to reboot the unit.
K
[RESET] Reset Button
This button functions in two different ways
depending on how it is pressed.
● Reset function
Press and release the button within two seconds
to restart VN-X35U. It takes about one minute for
the unit to restart, and the [RESET] button is
disabled during this interval.
● Focus Assist function
Press and hold down for at least two seconds
but less than five seconds. The L [STATUS]
indicator starts blinking in green color, and the
Focus Assist mode is enabled.
(A Page 24)
You can also perform the same operation on the
viewer.(A Page 83)
J
K
MONITOR OUT
PAL
OFF NTSC
RESET
STATUS
IRIS
M
L
Memo:
Pressing and holding the button for five seconds
or longer enables the service confirmation
mode. The L [STATUS] indicator lights up in
orange color in this mode. Do not press the
button for 5 seconds or longer.
L
[IRIS] Iris Terminal
Use this terminal to connect the DC iris lens.
(Connection with the video iris lens is not
possible.)
(A Page 16)
M
[STATUS] Status Indicator
This status of this product is indicated in green
or orange color.
Starting up: Lights up in orange
Startup complete: Lights up in green
Error: Blinks in orange
Memo:
● The indicator alternates lighting up in green
color and orange color repeatedly when in
the Focus Assist mode. (A Page 24)
● Blinks in green color when "Identify Unit" is
set to "Blink" (A Page 75).
● You can turn off the indicator after startup is
complete using the [LED State] of the
integrated viewer. (A Page 75)
11

Advertisement

Table of Contents
loading

Table of Contents