Rear - JVC VN-X35U Instructions Manual

VN-V25U_26U_EN.book Page 12 Wednesday, September 3, 2008 8:03 PM
Getting Started

Rear

N
[MONITOR OUT] Monitor Video Signal
Output Terminal (RCA)
This is an output terminal for composite video
signals (1 V (p-p), output impedance of 75 K).
Use this terminal to connect to devices such as a
video monitor.
This terminal is used for adjusting the camera
angle during installation. (A Page 19)
Memo:
● Use the J [MONITOR OUT] switch to select
the availability of output as well as the signal
system. When the switch is changed, press
the K Reset button to reboot the unit.
● When using the [MONITOR OUT] output, set
the privacy mask to AOffB. (A Page 63)
O
[10BASE-T/100BASE-TX]
Use this terminal to connect to the network via a
LAN cable.
This product supports PoE (IEEE802.3af) and
therefore can be used without a power cable.
PoE: class 0
(A Page 17,18)
P
[ALARM INPUT/OUTPUT] Alarm Input/
Output Terminals
Use these terminals to connect to an external
alarm device.
(A Page 20)
12
Q
P
1 2
G 2 1 2 1
AC24V
ALARM
R
MONITOR
S
OUT
AUDIO
10BASE-T/
SEE INSTRUCTION MANUAL 100BASE-TX
CAUTION
PoE AC 24V
: NEVER USE AND AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
PUSH
N O
Q
[AC24V] Power Input Terminal
Use this terminal to connect to an AC 24 V,
50/60 Hz power supply.
(A Page 17)
R
Fall Prevention Wire Mounting Screw
(M3 x 6 mm)
Use this screw to mount the fall prevention wire.
(A Page 21)
S
[AUDIO IN/OUT] Audio Signal Input/
Output Terminal(Mini jack, R3.5, stereo)
This is an audio input/out terminal. Connect
using a mini jack R3.5 stereo cable.
(A Page 19)