Using The Poe; Lan Cable Connection - JVC VN-X35U Instructions Manual

VN-V25U_26U_EN.book Page 18 Wednesday, September 3, 2008 8:03 PM
Connection / Installation
Power Connection (continued)
● In a system where multiple units of VN-X35U
are used, turn on the power of only one unit
to configure the IP address settings using the
Internet Explorer. Upon doing so, turn on the
power of the second unit and configure
accordingly. Configure the camera settings
using the same procedure.
● When overlapping of the IP address occurs,
check to ensure that there is only one
VN-X35U unit within the same LAN
environment, and wait for a while (at least 10
minutes) or power off and on all network
devices under the same LAN environment.
Otherwise, access to VN-X35U may fail.
● When there is an overlap of IP address, access
to VN-X35U may fail. When this occurs, turn on
the power of only one VN-X35U
same LAN environment and wait for a while (at
least 10 minutes). Alternatively, turn off the
power of all network devices connected to the
same LAN environment, followed by turning
them on again.

Using the PoE

Connect to a device that supports PoE to supply
electricity from the LAN cable.
1 2
G 2 1
AC24V
ALARM
MONITOR
OUT
10BASE-T/
SEE INSTRUCTION MANUAL 100BASE-TX
CAUTION
PoE AC 24V
: NEVER USE AND AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
Memo:
● For details on the connection method and
cable type, please refer to ALAN Cable
ConnectionB (A Page 18).
What is PoE (Power over Ethernet)?
This is a function that enables operation of a
LAN equipment without a power cable by
supplying power simultaneously with the data
using a LAN cable.
18

LAN Cable Connection

Connect the camera to a hub or computer using
a LAN cable.
Cable to use
unit within the
Note:
2 1
● However, cross cables cannot be used with
Memo:
● Make use of a Category 5 (or higher) cable
AUDIO
● To distribute images to the network, set the
PUSH
Connect to PoE-
compatible device
● Shielded cable
● Length of 100 m or shorter
When connecting to a hub
Make use of a straight cable.
When connecting to a computer
Make use of a cross cable.
1 2
G
2 1
1 2
G 2 1
AC24V
ALARM
AC24V
ALARM
MONITOR
OUT
10BASE-T/
MONITOR
100BASE-TX
SEE INSTRUCTION MANUAL
OUT
CAUTION
PoE AC 24V
: NEVER USE AND 10BASE-T/ AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
SEE INSTRUCTION MANUAL 100BASE-TX
CAUTION
PoE AC 24V
: NEVER USE AND AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
some computer models. When connecting
VN-X35U directly to a computer, check the
computer's LAN specifications in advance.
when 100BASE-TX is used.
[MONITOR OUT] switch at the side of this
product to AOFFB.
[MONITOR OUT] Switch
MONITOR OUT PAL OFF NTSC
STATUS
2 1
2 1
AUDIO
AUDIO
PUSH
PUSH
RESET
IRIS