JVC VN-X35U Instructions Manual page 57

VN-V25U_26U_EN.book Page 57 Wednesday, September 3, 2008 8:03 PM
B
FTP Time Filter:
For specifying the periodic FTP transfer action with respect to each day of
the week and setting the corresponding time of the day.
Applicable day of week : Sunday, Monday, Tuesday, Wednesday,
Alarm action
Applicable time period : For specifying the start and end time in hours and
Pre-/Post-recording parameter:
[PrePostRecording Frame Rate]
[PrePostRecording Before Trigger] : For setting the FTP pre-recording
[PrePostRecording After Trigger]
Memo:
The maximum time intervals for [PrePostRecording Before Trigger] and
[PrePostRecording After Trigger] are determined by the JPEG size on the
Encoding page as well as the set values for [PrePostRecording Frame Rate].
A message appears if the combination of the entered values are not feasible.
C
Alarm Output For setting the alarm output.
Duration For setting the output time of [Manual Output].
[Setting range: 0, 100 msec to 5000 msec]
Manual For operating alarm output manually.
Output
The current output status appears on the right. When [Duration] is set to "0",
pressing the [Make] button switches the alarm to Make output, while
pressing the [Break] button switches the alarm to Break output.
When [Duration] is set to a value other than "0", pressing the [Make] button
switches the alarm to Make output only during the duration of the output,
upon which it switches to Break output.
When the output duration is set to a value other than "0", pressing the
[Break] button switches the alarm to Break output only during the duration of
the output, upon which it switches to Make output.
Thursday, Friday, Saturday
Unmask Span : For specifying the time period for invoking the
action
Mask Span : For specifying the time period to stop the action
Unmask All : Activated at all times
Mask All : Stopped at all times
minutes.
: For specifying the JPEG frame rate for
FTP pre-/post-recording.
trigger time (recording time before
alarm input) in seconds.
[Setting range: 0 to 60 seconds]
: For setting the FTP post-recording
trigger time (recording time after alarm
input) in seconds.
[Setting range: 0 to 60 seconds]
57